Have you had home flood damage in San Diego? You may be able to prevent having a moldy carpet after water damage by following these 6 steps.
The sooner you start tidying up after water damage, the much better opportunities you have of preventing mold from forming below your carpeting.

1. Get rid of the water. Use a wet/dry vacuum to clean up as much of the water as possible.
2. Use a dehumidifier. Get rid of extreme moisture and minimize humidity levels with dehumidifiers. This will not only make the air feel cooler, however it will likewise limit the development of mold and mildew.
3. Speed drying procedure with fans. One of the first things you wish to do is get fresh air circulating.
4. Treat carpet and flooring. All carpets should be steam cleaned to correctly sanitize and ventilate. Typically water harmed padding should be changed.
5. Sanitize walls and walls. Everything touched by storm water should be sanitized. Clean all walls, hard-surface floors and other home surface areas with soap and water and sanitize them with an option of 1 1/2 cups of chlorine bleach to one gallons of water. Bear in mind to clean your hands regularly during clean up and constantly wear rubber gloves.
6. Inspect furnishings. Look for damage and lift off wet flooring.
Cleaning water-soaked carpetings and floors is challenging under any conditions, however in the results of a storm or flood, contamination by mud, silt, sewage and mildew, it can compound the issue. The Institute for Inspection Cleaning & Restoration Certification (IICRC) recommends that it is constantly best to have water and mold evaluated and eliminated by a licensed specialist.

Mold on Carpet

If you can see significant mold development on wall to wall carpeting in your home then you have to get rid of the carpet. Sadly there’s no chance to completely get rid of mold from fixed carpets. And ignoring mold on the carpet will just result in the issue worsening.

Wet Carpet

The same goes for carpet that has been wetted right through. When the padding on the bottom of carpeting splashes it takes a long time to dry, much longer than the 24-48 hours mold needs to grow. Although the leading layer of carpet could seem to dry relatively rapidly, the layer of padding beneath stays damp long after.

Changing Part of  Carpet

If only a small area of your carpet got wet or has mold on it then you can cut out and remove simply the afflicted part of the carpeting. When you’re cutting out the carpeting ensure to cut an extra 12 inches on each side further than the moldy or damp part. You can then change it with a brand-new section of carpet, as long as you don’t mind the small cosmetic distinction of having a section which might not completely match the rest.
Make certain to let the floor dry out appropriately if it’s still wet prior to you place the brand-new piece of carpeting. It’s also a good idea to HEPA vacuum too, once the floor is dry, before you install the brand-new section of carpet.

Eliminating Mold on Rugs and Non-Fixed Carpet

preventing moldy carpet San Diego CARugs or carpets that aren’t wall to wall, permanently-fixed carpeting can be cleaned to eliminate mold. The very best thing is to talk with a professional carpet cleaning service or mold removal expert. Make certain they understand ways to eliminate mold from carpetings or rugs and they have actually had experience at it. You should have the ability to eliminate the carpeting and send it to them to skillfully clean and dry it to remove the mold.
If you want to attempt to clean the moldy carpet yourself  you ought to first take it outside. Then spread it out, for example on the driveway, and hose both sides.

Next use a mold eliminating or cleaning option on the moldy location of the carpeting and scrub the mold away. Some of the most effective mold killers and cleaners can be discovered at Killing Mold. After you have completed you should wash the carpet well.
Use a damp vacuum on the carpet, if you have one, to assist dry it out much faster as soon as you’ve washed it. Then let the carpet dry in the sun, ensuring both sides get totally dried. Only take the carpeting back into your house if it is perfectly dry all the way through.
As soon as the carpeting’s dry HEPA vacuum it to remove any mold spores that might be left in it. Beating the carpet on the line when it’s dry also assists to eliminate mold spores and other dirt and dust from it.

If you have moldy carpet problems in your business, office or church call us.